HOW IT WORKS
1. CLEAN AREA ON FACE
Use warm water and soap (or alcohol swab) to thoroughly clean and dry area below the eye where the tattoo is going to be placed in order to ensure the best results.
2. CUT OUT TATTOO
Take scissors and cut about .15 – .25 inches around tattoo, leaving room to be able to grab the plastic backing without pulling off the tattoo.
3. PEEL AWAY PLASTIC
Peel off the plastic transfer sheet with tattoo on it from the paper backing. Eyeblack Tattoo will now be on the plastic transfer sheet and ready to apply.
4. PLACE ON SKIN, PRESS & HOLD
Place the plastic sheet with tattoo side down onto the skin, and place hand over-top of the tattoo, covering as much surface areas as possible. Hold down firmly for 45 seconds allowing heat to transfer the tattoo onto the skin. No water needed.
5. PULL AWAY PLASTIC BACKING
Grab an edge of the plastic and begin to pull. Make sure the tattoo has transferred onto the skin completely. If it has not, place back down and continue to hold. When tattoo has transferred, pull away the plastic backing.
TO REMOVE - GRAB EDGE OF TATTOO AND PULL
To remove the tattoo, carefully peel back an edge of the tattoo from skin and slowly begin to pull off the eyeblack tattoo. Removal is painless and takes just seconds.